Great Wiring A Fan Light Combo

For this you ll need three twist on wire connectors.

Wiring a fan light combo. The wiring method for the circuit will either have the circuit power located up in the ceiling or down at the wall switch box. Remove the outer jacket from all the cable ends using the cable ripper or the razor knife. Find the short green wire or the green ground screw on your ceiling fan hanging.

When the circuit power is located at the wall box for the switches the wiring will be much less confusing and easier to wire. Powered ceiling fan and or light without any switches no switches switching the light and using the pull chain for the fan single switch switching the light and fan from the same switch single switch. I also used a diagram picture thanks for watching.

The four methods are. Push the the fan light box into the ceiling opening until it snaps in place. Remove 3 4 inches of.

The first connector will join the black power supply wire from the electrical box to the black and blue. In this wiring the source is at the switch and 3 wire cable runs from there to the fan and light. Wiring a fan and light to a single switch.

The blue wire is the hot wire for the ceiling fan light fixture. The source neutral and ground are spliced through to the fan location. The white neutral wires would be tied together at the wall switch box.

Understand that this is a typical wiring scenario however the actual wiring connections may be different for your specific unit especially at the unit connections as well because. Cables and neutral wire connections. The wiring diagram above is for typical installation wiring light is switched the fan is powered by a pull chain once you have found and identified all of the wires on your fan and in your electrical box you can get to work on connecting them.