Matchless Dimmer Switch On 2 Way Circuit

You use a simple push button to operate dim the lights.

Dimmer switch on 2 way circuit. 3 way dimmer switches and compatibility electrical question. There are 2 modes of operation. So you would need to purchase a two gang master dimmer to replace the two way switch and a single gang slave dimmer for the other switch and connect load and slave terminals between the switches.

Yes you just have to buy the right dimmer. In order to install a two way dimmer switch you need to understand a little bit about different types of switches. This is what i ve used it switched on the ve side so the lights in the rear are switched by the courtesy circuit too.

Is it possible to have two three way dimmer switches. This means that it is the only control for the light. In the usa we would call this type of circuit a 3 way while other countries yours included refer to it as a 2 way circuit.

You cannot normally fit two dimmers to a 2 way lighting circuit you can fit a dimmer at one end only as you get a fluctuation imbalance between two dimmers on one circuit. However you can set up specialized two way dimmers using a master and slave switch. I really would like to see a diagram of it where the dimmer will be on the end of the circuit.

I want to know if its possible to put two dimmer switches on one light. Here in the usa most dimmers are compatible with 3 way circuits. Remember the last brightness or come in full.

Some switches are called two way switches. You can have as many push buttons as you want. I m not sure if that s true in your area so you ll have to verify when buying the dimmer.